ds1200 1200 watts distributed power system distributed power bulk front-end total output power: 1200 watts +3.3 vdc stand-by output wide range input voltage: 90 - 264 vac special feature s ? active power factor correction ? en61000-3-2 harmonic compliance ? active ac inrush control ? 1u x 2u form factor ? 21.71 w/in3 ? +12 vdc output ? +3.3 vdc or +5.0 vdc stand-by ? no minimum load required ? hot plug operation ? n + 1 redundant ? internal oring fets ? active current sharing (10 - 100% load) ? built-in cooling fan (40 mm x 28 mm) ? i 2 c communication interface bus ? pmbus compliant ? eeprom for fru data ? red/green bi-color led status ? internal fan speed control ? fan fail tach output signal ? full digital control ? two year warranty safety ? ul/cul 60950 (ul recognized) ? nemko+ cb report en60950 ? en60950 ? ce mark ? china ccc electrical specifcations input input range: 180 - 264 (1200 w) 90 - 264 (1000 w) frequency: 47-63 hz, single phase ac inrush current: 40 apk maximum inrush current effciency: > 91% typical at high line 50% load conducted emi: fcc subpart j en55022 class b radiated emi: fcc subpart j en55022 class b power factor: 0.99 typical leakage current: 1.40 ma @ 240 vac hold up time: 12 ms minimum output main dc voltage: +12 v @ 100 a (high line) +12 v @ 81.6 a (low line) stand-by: +3.3 vsb @ 6 a (5 v @ 4 a available) adjustment range: 5% on +12v only using i 2 c regulation: +12 vdc; +5%/-5% +3.3 vsb; +5%/-5% over current: +12 vdc; latches off if overcurrent lasts over 1 second, otherwise it is auto recovery (see table 1 next page) +3.3 vsb, 9 a max (hiccup mode) over voltage: +12 vdc; 13.2 - 14.4 vdc +3.3 vsb; 3.76 - 4.30 vdc under voltage: +12 vdc; 9 - 10.8 v (latch off) turn-on delay: 2 second max, 5 - 50 ms, monotonic rise main output rise time: 5 - 50 ms, monotonic rise data sheet power
ds1200 series data sheet logic control ps_seated (a4): ttl logic low if power supply is seated into system connector. this is a short pin. a logic high if the psu is removed pwr good (c3): active ttl high when output is within regulation limits. ac ok (b1): a low logic level if the input voltage is within allowable limits. a ttl logic high level, and a 5ms early warn - ing signal before 12.0 v dc output loss of regulation. ps_inhibit/ps_kill (b4): when left open power supply operation will be inhibited. when the power supply is inserted into the system, this pin will be pull low by the system and turn the power supply on only after all other power supply pins have seated. ps on (a1): the output will be enabled when this signal is pulled low, below 0.8 v outputs disabled when pin is driven high or left open. environmental specifcations operating temperature: -10 to 50 c storage temperature: -40 c to +85 c altitude, operating: 10,000 ft electromagnetic susceptibility/input transients: -en61000-3-2, -3-3 -en61000-4-2, 4.3, 4-4, -4-5, 4-11 -en55024:1998 rohs & lead-free compliant: no tantalum caps. humidity: 20 to 90% rh, non-condensing shock and vibration specifcatons: complies with standard operating/non-operating random shock and vibration mtbf (demonstrated): 500k hrs at full load, 25 c
ds1200 series data sheet ordering information model number nominal output voltage set point set point tolerance total regulation minimum current maximum current output ripple p/p over current stand-by air flow DS1200-3 12.0 vdc 0.2% 5% 0 a 100 a 120 mv 118 a - 147.6 a * 3.3 v @ 6 a std DS1200-3-002 12.0 vdc 0.2% 5% 0 a 100 a 120 mv 118 a - 147.6 a* 5.0 v @ 4 a std DS1200-3-003 ** 12.0 vdc 0.2% 5% 0 a 100 a 120 mv 118 a - 147.6 a* 3.3 v @ 6 a rev DS1200-3-004 ** 12.0 vdc 0.2% 5% 0 a 100 a 120 mv 118 a - 147.6 a* 5.0 v @ 4 a rev * over current latches off if overcurrent lasts over 1 seconds, otherwise it is auto recovery. derating may apply.
ds1200 series data sheet mechanical drawing condition led status stand-by - on; main output - off; ac present blinking green stand-by - on; main output - on; solid green main output ocp, uvp, ovp blinking amber fan_fault; otp; stand-by ocp/uvp amber
ds1200 series data sheet worldwide offices americas 2900 s.diablo way tempe, az 85282 usa +1 888 412 7832 e urope (uk) waterfront business park merry hill, dudley west midlands, dy5 1lx united kingdom +44 (0) 1384 842 211 a sia (hk) 14/f, lu plaza 2 wing yip street kwun tong, kowloon hong kong +852 2176 3333 for more information: www.artesyn.com/power for support: productsupport.ep@artesyn.com while every precaution has been taken to ensure accuracy and completeness in this literature, artesyn embedded technologies assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. artesyn embedded technologies, artesyn and the artesyn embedded technologies logo are trademarks and service marks of artesyn embedded technologies, inc. all other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. ? 2014 artesyn embedded technologies, inc. www.artesyn.com ds1200 series-ds 09.09.14 dc output connector pinout assignment male connector as viewed from the rear of the supply: d1 d2 d3 d4 d5 d6 pb1 pb2 pb3 pb4 pb5 pb6 c1 c2 c3 c4 c5 c6 b1 b2 b3 b4 b5 b6 a1 a2 a3 a4 a5 a6 pin assignments pin signal name pb 1 main output return pb 2 main output return pb 3 main output return pb 4 + main output pb 5 + main output pb 6 + main output a1 ps_on a2 main output remote sense return a3 spare a4 ps_seated (power supply seated) a5 stand-by a6 stand-by return b1 ac_ok (ac input present) b2 main output remote sense b3 main output current share b4 ps_inhibit/ps_kill b5 stand-by b6 stand-by return pin assignments pin signal name c1 sda (i 2 c data signal) c2 scl (i 2 c clock signal)* c3 power good c4 spare c5 stand-by c6 stand-by return d1 a0 (i 2 c address bit 0 signal) d2 a1 (i 2 c address bit 1 signal) d3 s_int (alarm) d4 stand-by rmt sense d5 stand-by d6 stand-by return *supports i 2 c standard mode (100 khz) only p1 - power supply side 1 fci power blade 51721 series 51721-10002406aa 2 molex power connector sd-87667 series 87667-7002 mating connector (system side) 1 fci power blade 51741-10002406cc strait pins 2 fci power blade 51761-10002406aalf right angle
|
